Hi Guys,
I have setup a vpn with the shrew vpn client to an netgear prosafe firewall.
The tunnel is enabled, but I cannot reach anything on the other side.
Could it be that there is no correct route?
When I enter route print on the client side I see the foloowing:
IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 192.168.10.1 192.168.10.101 20
127.0.0.0 255.0.0.0 On-link 127.0.0.1 306
127.0.0.1 255.255.255.255 On-link 127.0.0.1 306
127.255.255.255 255.255.255.255 On-link 127.0.0.1 306
172.16.0.0 255.255.255.0 On-link 198.18.0.0 31
172.16.0.255 255.255.255.255 On-link 198.18.0.0 286
192.168.10.0 255.255.255.0 On-link 192.168.10.101 276
192.168.10.101 255.255.255.255 On-link 192.168.10.101 276
192.168.10.255 255.255.255.255 On-link 192.168.10.101 276
198.18.0.0 255.254.0.0 On-link 198.18.0.0 286
198.18.0.0 255.255.255.255 On-link 198.18.0.0 286
198.19.255.255 255.255.255.255 On-link 198.18.0.0 286
217.100.120.106 255.255.255.255 192.168.10.1 192.168.10.101 21
224.0.0.0 240.0.0.0 On-link 127.0.0.1 306
224.0.0.0 240.0.0.0 On-link 192.168.10.101 276
224.0.0.0 240.0.0.0 On-link 198.18.0.0 286
255.255.255.255 255.255.255.255 On-link 127.0.0.1 306
255.255.255.255 255.255.255.255 On-link 192.168.10.101 276
255.255.255.255 255.255.255.255 On-link 198.18.0.0 286
local client ip is 192.168.10.101
virtual network of the shrew client 198.18.0.0
remote internal network is 172.16.0.0
Can anyone help me out here?
